SKU: SSNR-8511
Stick-Stitch-N-Rinse

Wash-Away

Ideal for embroidery on plush fabrics

100% PVA Film dissolves in water or when laundered

Prevents stitches from being buried into heavy, thick, plush fabrics

Great for monogramming on heavy fabrics and terry cloth robes

Great for thread-play applications

Design will lay flat and smooth after washing away the excess stabilizer

EASY INSTRUCTIONS

CUT Bosal Wash Away to the desired hoop width.  Make sure that the film is flat and smooth when locked into the hoop.  For appliques, monogramming and lace, it is best to lay the film on top of the area to be embroidered.  Lock the film on top of the fabric and into the hoop.  Trim away excess with scissors and remove remaining film with a sponge or through the laundering process.

Instructions

1.       Based on the chart below, calculate the amount of fabric you need to begin with, about 3% lager than your finished product.  Please note that the values are approximate.

2.       Layer Stitch & Steam on wrong side of fabric and pin. If using fusible batting, fuse the batting to the fabric first, then layer with Stitch & steam.  If using sew-in batting, layer the batting between your fabric and stitch & Steam and proceed as usual.

3.       Mark desired stitching grid and stitch through all layers.  The amount of texture achieved depends on the density of the grid.  The tighter the grid the more texturized the project will be.

4.       Set iron to cotton/high heat setting.  With fabric face up on your ironing board and stitch & Steam face down, hover close to the fabric & steam.  Wait for shrinkage to occur, usually just a few seconds.  Continue steaming around entire piece of fabric until shrinking stops and fabric lies flat.

5.       Cut to desired dimensions and sew as usual.